ES-4024A User’s Guide
76 Chapter 7 Basic Setting
7.7.1 IP Interfaces
The switch needs an IP address for it to be managed over the network. The factory default IP
address is 192.168.1.1. The subnet mask specifies the network number portion of an IP
address. The factory default subnet mask is 255.255.255.0.
On the switch, as a layer-3 device, an IP address is not bound to any physical ports. Since each
IP address on the switch must be in a separate subnet, the configured IP address is also known
as IP interface (or routing domain). In addition, this allows routing between subnets based on
the IP address without additional routers.
You can configure multiple routing domains on the same VLAN as long as the IP address
ranges for the domains do not overlap. To change the IP address of the switch in a routing
domain, simply add a new routing domain entry with a different IP address in the same subnet.
Figure 32 IP Setup
The following table describes the labels in thes screen.
Table 11 IP Setup
LABEL DESCRIPTION
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
Domain
Name Server
DNS (Domain Name System) is for mapping a domain name to its corresponding IP
address and vice versa. Enter a domain name server IP address in order to be able to
use a domain name instead of an IP address.
Apply Click Apply to save the settings.
Cancel Click Cancel to reset the fields to your previous configuration.
IP Address Enter the IP address of your switch in dotted decimal notation for example 192.168.1.1.
This is the IP address of the switch in an IP routing domain.
