Chapter 33 Command Examples
VES-1616F-3x Series User’s Guide
249
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100.
33.5 Enabling RSTP
Syntax:
snapping-tree [port-number]
To enable RSTP on a port. Enter spanning-tree followed by the port number and press
[ENTER]. The following example enables RSTP on port 17.
33.6 vdsl-port Command
Syntax:
vdsl-port <port-list> profilename <name-str>
where
This command sets the specified VDSL port(s) to use a VDSL profile. The following example
configures VDSL ports 1 to 5 to use the
test VDSL profile.
33.7 Configuration File Maintenance
This section shows you how to backup or restore the configuration file on the switch using
TFTP.
33.7.1 Backing up Configuration
Syntax:
copy running-config tftp <ip> <remote-file>
sysname> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
sysname(config)# spanning-tree 17
sysname#
<port-list> =
Selects the VDSL port(s) (port 1 to 16).
<name-str> =
Specifies the name of the VDSL profile.
sysname(config)# vdsl-port 1-5 profilename test
