Filter
Top Products
3-5
Verifying Performance
Installing and Operating the Software
Installing and Operating the Software
Performance Test Software is supplied on a 3.5-inch, double-sided floppy disk and
is written to run with BASIC 5.0 and later. Modifications to the program should be
limited to changing the default addresses and storing copies for back-up purposes.
Understanding the
Tests
Test Descriptions contains a description of each test that is performed by the
Performance Test software. This description is intended to help locate problems if
the software fails to execute properly or to help users understand the test
methodology that is used in each performance test. The descriptions are not step by
step procedures for manual performance tests.
To Load the
Program.
To verify the performance of the Agilent 8922M, you need to convert the instrument
back from an Agilent 8922G, or convert the Agilent 8922S to an Agilent 8922E. To
do this refer to the following section titled “Using the Compatibility Switch - Back
Conversion”.
You are now ready to run the Performance Test Software.
1 Put the disk in the disk drive.
2 Type LOAD “PT_8922”, press .
After you have completed the Performance Tests, return the instrument back to the
Agilent 8922M or Agilent 8922S by following the instructions in the following
section titled “Using the Compatibility Switch - Forward Conversion”.
Using the
Compatibility
Switch
Back Conversion
To turn the instrument from the Agilent 8922M/S back to an Agilent 8922G or an
Agilent 8922E, select the following keys:
• CONFIG (this is accessible from the Cell Control screen in the bottom right-hand
corner).
• Compatible, select 8922G or 8922E
• HP-IB Adrs (22)
•
The instrument is now set up as an Agilent 8922G or Agilent 8922E and ready for
Performance Verification testing.
ENTER
PRESET