Open as PDF
Use only the supplied or an approved replacement
antenna. Unauthorized antennas, modifications, or
attachments could damage the phone and may violate
NORMAL POSITION: Hold the phone as you would any
other telephone with the antenna pointed up and over
Tips on Efficient Operation:
For your phone to operate most efficiently:
Do not touch the antenna unnecessarily when the
phone is in use. Contact with the antenna affects call
quality and may cause the phone to operate at a higher
power level than otherwise needed.
American National Standards Institute; National Council
on Radiation Protection and Measurements;
International Commission on Non-Ionizing Radiation
Check the laws and regulations on the use of wireless
telephones in the areas where you drive and always
obey them. Also, if using your phone while driving,
please observe the following:
TTIIAA SSaaffeettyy IInnffoorrmmaattiioonn
The following is the complete TIA Safety Information for
Wireless Handheld phones.
Exposure to Radio Frequency Signal
Your wireless handheld portable telephone is a low power
radio transmitter and receiver. When it is ON, it receives
and also sends out radio frequency (RF) signals.
In August, 1996, the Federal Communications
Commissions (FCC) adopted RF exposure guidelines
with safety levels for hand-held wireless phones.Those
guidelines are consistent with the safety standards previ-
ously set by both U.S. and international standards bodies:
ANSI C95.1 (1992) *
NCRP Report 86 (1986)
Those standards were based on comprehensive and
periodic evaluations of the relevant scientific literature.
For example, over 120 scientists, engineers, and physi-
cians from universities, government health agencies,
and industry reviewed the available body of research to
develop the ANSI Standard (C95.1).
The design of your phone complies with the FCC guide-
lines (and those standards).
Chapter 6 Safety Guidelines