Filter
Top Products
12
The phone rings and the call con-
nects like a normal telephone. A call
timer appears.
You can also get the following mes-
sages if the call does not connect or
you use the second line:
If the dialled number matches one
stored in the phone book then the
name of the called person appears
in the display.
Receiving a call
The phone rings (or vibrates, see
page 32 to set) when it receives a
call. See page 33 to set the incom-
ing ring tone. See page 34 to set the
backlight.
Answering the call
No ring
Pressing No ring stops the
sound of the ring tone, which al-
lows you to, for example, go out
of a room before pressing.
Service number presentation
If you have the service number
presentation your phone displays
the following information.
If you have a second line, ap-
pears when the call has been re-
ceived on your line 2 number (see
page 18 for details).
Rejecting the call
To reject, or return a busy signal
to the caller:
Ending a call
The phone stores the caller's
number, if available, in the received
calls log (see page 29).
Turning off the phone
The mobile turns off.
Battery
Low battery warning
When the battery power falls to its
lowest level the message Low Bat-
tery! appears and a low battery
To dial (send) the number press
.
You can prefix international calls with 00 or +. To
enter the + symbol before a number press and
hold down .
Your phone
displays...
if the...
Busy
called party is en-
gaged.
Not allowed
(fixed dial-
ling)
number dialled is
not authorised by
the FDN list (see
page 25).
call is made using
the second line
(see page 32).
Press .
If the ring tone volume is set to zero (off) or if the
phone has been set to 'Vibrate' mode, no sound is
heard.
2
Your phone dis-
plays...
if the
number
is...
Unknown number,
then Call1 when
connected
unavaila-
ble.
the caller’s number
available
but not in
phone
books.
Withheld number,
then Call1 when
connected
withheld.
Press .
Press . The call timer stops and
disappears.
Waiting a few seconds or pressing the Exit softkey
returns the phone to the stand-by display.
Press and hold down .