Mitsubishi Electronics 110 Cell Phone User Manual


 
3
Introduction
Introduction
Thank you for purchasing the Trium 110
dual band mobile telephone. The phone
version you have bought is either the
Trium 110, the Trium 110 m or the Tri-
um 110 p. Please check the version on
the box label. The mobile telephone de-
scribed in this guide is approved for use
on all GSM 900/1800 networks. Some
services and messages may be different
according to your subscription type
and/or service provider.
As with all types of radio transceivers
this mobile telephone emits electro-
magnetic waves and conforms to inter-
national regulations when it is used
under normal conditions and in accord-
ance with the safety and warning mes-
sages given below and on page 4.
SAR
THIS TRIUM 110, TRIUM 110 m OR TRI-
UM 110 p PHONE MEETS THE EU RE-
QUIREMENTS FOR EXPOSURE TO RADIO
WAVES.
Before a mobile phone is available for
sale to the public, compliance with the
European R&TTE directive (1999/5/CE)
must be shown. This directive includes
as one essential requirement the pro-
tection of the health and the safety for
the user and any other person.
Your mobile phone is a radio transmitter
and receiver. It is designed and manufac-
tured not to exceed the limits for expo-
sure to radiofrequency (RF) energy
recommended by The Council of the Eu-
ropean Union
1
. These limits are part of
comprehensive guidelines and establish
permitted levels of RF energy for the
general population. The guidelines were
developed by independent scientific or-
ganisations through periodic and thor-
ough evaluation of scientific studies. The
limits include a substantial safety margin
designed to assure the safety of all per-
sons, regardless of age and health.
The exposure standard for mobile
phones (CENELEC standard EN 50360:
2000) employs a unit of measurement
known as the Specific Absorption Rate,
or SAR. The SAR limit
2
recommended by
The Council of the European Union is
2.0 W/kg. Tests for SAR have been con-
ducted using standard operating posi-
tions (with reference to CENELEC
standard EN 50361: 2000) with the
phone transmitting at its highest certi-
fied power level in all tested frequency
bands
3
. Although the SAR is determined
at the highest certified power level, the
actual SAR level of the phone while op-
erating can be well below the maximum
value. This is because the phone is de-
signed to operate at multiple power lev-
els so as to use only the power required
to reach the network. In general, the
closer you are to a base station antenna,
the lower the power output.
The highest SAR value for this Trium
110, Trium 110 m or Trium 110 p model
when tested for compliance against the
standard was 0.746 W/kg. While there
may be differences between the SAR
levels of various phones and at various
positions, they all meet the EU require-
ments for RF exposure.
1. European recommendation 1999/519/CE
2. The SAR limit for mobile phones used by the
public is 2.0 watts/kilogram (W/kg) averaged
over ten grams of tissue. The limit incorpora-
tes a substantial margin of safety to give
additional protection for the public and to
account for any variations in measurements
3. The maximum level of GSM emitted power is
250mW at 900 MHz and 125 mW at
1800MHz according to the GSM standard.