Filter
Top Products
● DNS addresses — Enter the IP addresses of the primary and secondary DNS servers,
if required by your service provider. To obtain these addresses, contact your internet
service provider.
● Proxy server address — Enter the address of the proxy server.
● Proxy port number — Enter the port number of the proxy server.
WLAN internet access points
Select Menu > Settings and Connectivity > Destinations > Access point, and
follow the instructions on the screen.
To edit a wireless LAN (WLAN) access point, open one of the access point groups and
select an access point marked with
.
Follow the instructions from your WLAN service provider.
● WLAN network name — Select Enter manually or Search for networks. If you
select an existing network, WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
● Network status — Define whether the network name is displayed.
● WLAN network mode — Select Ad-hoc to create an ad hoc network and to allow
devices to send and receive data directly; a WLAN access point device is not needed.
In an ad hoc network, all devices must use the same WLAN network name.
● WLAN security mode — Select the encryption used: WEP, 802.1x (not for ad hoc
networks), or WPA/WPA2. If you select Open network, no encryption is used. The
WEP, 802.1x, and WPA functions can be used only if the network supports them.
● Homepage — Enter the web address of the starting page.
● Use access point — Select After confirmation if you want the device to ask for
confirmation before the connection using this access point is created or
Automatically if you want the device to connect to the destination using this access
point automatically.
To enter the settings for the selected security mode, select WLAN security settings.
Security settings for WEP
● WEP key in use — Select the wired equivalent privacy (WEP) key number. You can
create up to four WEP keys. The same settings must be entered on the WLAN access
point device.
● Authentication type — Select Open or Shared for the authentication type between
your device and the WLAN access point device.
● WEP key settings — Enter WEP encryption (length of the key), WEP key format
(ASCII or Hexadecimal), and WEP key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2
● WPA/WPA2 — Select the means of authentication: EAP to use an extensible
authentication protocol (EAP) plug-in, or Pre-shared key to use a password.
Complete the appropriate settings:
● EAP plug-in settings — Enter the settings according to the instructions from
your service provider.
© 2008 Nokia. All rights reserved.74