Filter
Top Products
Make calls
67
• Ensure that both the sender and recipient are
registered to the UMTS network. If you invite someone
to a sharing session and the recipient’s device is turned
off, is not within UMTS network coverage, or does not
have Video sharing installed or person-to-person
connections set up, the recipient does not know that
you are sending an invitation. However, you receive an
error message that the recipient cannot accept the
invitation.
Settings
Person-to-person connection settings
A person-to-person connection is also known as a Session
Initiation Protocol (SIP) connection. The SIP profile settings
must be configured in your device before you can use
Video sharing. Setting up a SIP profile allows you to
establish a live person-to-person connection to another
compatible device. The SIP profile must also be established
to receive a sharing session.
Ask your network operator or service provider for the SIP
profile settings, and save them in your device. Your
network operator or service provider may send you the
settings over the air or give you a list of the needed
parameters.
If you know a recipient’s SIP address, you can enter it on
the person’s contact card. Open Contacts from your device
main menu, and open the contact card (or start a new card
for that person). Select Options > Add detail > SIP or
Share view (the correct option depends on the network
operator). Enter the SIP address in the format
username@domainname (you can use an IP address
instead of a domain name).
If you do not know a SIP address for the contact, you can
also use the already saved phone number of the recipient
including the country code, for example +358, to share
video. If the phone number saved in Contacts does not
include the country code, you can enter the number
including the country code when sending the invitation.
UMTS connection settings
To set up your UMTS connection, do the following:
• Contact your service provider to establish an
agreement for you to use the UMTS network.
• Ensure that your device UMTS access point connection
settings are configured properly. For help, see
‘Connection’, p. 104.
Share live video and video clips
To receive a sharing session, the recipient must install
Video sharing and configure the required settings on their
compatible mobile device. You and the recipient must
both be registered to the service before you can start
sharing.