Nokia N8 Cell Phone User Manual


 
Access point name — The access point name is
provided by your service provider.
User name — The user name may be needed to
make a data connection, and is usually provided
by your service provider.
Prompt password — If you want to set the
device to ask for a password every time you log
in to a server, or if you do not want to save your
password in the device, select Yes.
Password — A password may be needed to
make a data connection and is usually provided
by your service provider.
Authentication — Select Secure to always send
your password encrypted or Normal to send
your password encrypted when possible.
Homepage — Depending on the access point
type you are setting up, enter the web address
or the address of the multimedia message
centre.
Use access point — Select After confirmation
to set the device to ask for confirmation before
the connection using this access point is created,
or Automatically to set the device to connect to
the destination using this access point
automatically.
Select Options > Advanced settings and from the
following:
Network type — Select the internet protocol
type to transfer data to and from your device. The
other settings depend on the selected network
type.
Phone IP address (for IPv4 only) — Enter the IP
address of your device.
DNS addresses — Enter the IP addresses of the
primary and secondary DNS servers, if required
by your service provider. To obtain these
addresses, contact your internet service
provider.
Proxy server address — Enter the address of
the proxy server.
Proxy port number — Enter the port number
of the proxy server.
WLAN internet access points
Select Menu > Tools > Settings and
Connection > Destinations > Access point, and
follow the instructions on the display. Or, open one
of the access point groups, select an access point
marked with
, and select Edit.
Use the instructions provided by your service
provider to edit the following:
WLAN network name — Select Enter
manually or Search for networks. If you select
an existing network, WLAN network mode and
WLAN security mode are determined by the
settings of its access point device.
Network status — Define whether the network
name is displayed.
165
Settings