Filter
Top Products
SpectraLink Corporation Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-E.doc Page 12
2.4 Startup Sequence
The Wireless Telephone goes through an initialization sequence at startup. The line icons
1-9 display and count down as the Wireless Telephone steps through this sequence. This
is usually very rapid. If there is any difficulty at any step that prevents initialization from
continuing, an error message will display and the associated icon(s) will stay on. Please
see the error table at the back of this document for instructions on how to handle error
messages that occur during initialization.
Icon The icon(s) shown in bold turns off when:
123456789
The Wireless Telephone has located and authenticated and associated with at
least one AP, and is proceeding to bring up higher-layer networking functions.
12345678
The Wireless Telephone is either configured for Static IP, or if configured for DHCP
the DHCP discovery process has started.
1234567
If DHCP is configured, a DHCP response was received which contains a good DNS
server configuration.
123456
Note: Only valid on non-SRP protocol. Indicates one of the following:
Static IP configuration, or
SVP Server address found in DHCP response, or
SVP Server address found via DNS lookup.
12345
All networking functions are complete (notably, DHCP) and the Wireless Telephone
is proceeding with establishing the SRP link to either the Gateway or SVP Server.
1234
The SRP link is established, all network stack initialization is complete, proceeding
with application-specific initialization.
123
The link between the Wireless Telephone and the SVP Server is established.
(no icons)
EXT. XXX
Initialization is complete. The Wireless Telephone is in standby mode ready to
receive and place calls.