SpectraLink Corporation Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-E.doc Page 34
Message Description Action
Network Busy All APs are full or busy Try the call again later.
Wireless Telephone not registered
on NetLink Telephony Gateway
Verify that the NetLink Telephony
Gateway is properly configured.
NetLink Telephony Gateway is not
working
Verify that the NetLink Telephony
Gateway is powered on. If so,
follow standard NetLink Telephony
Gateway troubleshooting
procedures.
No GW Response
No LAN connection at the AP or
NetLink Telephony Gateway
Verify NetLink Telephony Gateway
connection to LAN and all APs.
No IP Address Invalid IP Check the IP address of the
Wireless Telephone and re-
configure if required.
No Net Access Cannot authenticate / associate with
AP
Verify the AP configuration.
Verify that all the WEP settings in
the Wireless Telephone match
those in the APs.
This indicates any of the following:
• No radio link
Verify that the AP is turned on.
• No ESSID – Auto-learn not
supported (or)
• Incorrect ESSID
Verify the ESSID of the wireless
LAN and enter or Auto-learn it
again if required. See Wireless
Telephone Configuration section.
• AP does not support appropriate
data rates
Check the AP configuration against
Configuration Note for AP.
No Net Found
• Out of range
Try getting closer to an AP. Check
to see if other Wireless
Telephones are working within the
same range of an AP. If so, check
the ESSID of this Wireless
Telephone.
• Incorrect WEP settings
Verify that all the WEP settings in
the Wireless Telephone match
those in the APs.
No Reg Domain Regulatory Domain not set Configure the Regulatory Domain
of the Wireless Telephone
No PBX No communication with host
telephone system.
Displays before the system has
synchronized ports with the host
telephone system. Should
disappear when the ports are
correctly wired and programmed.
Make sure the proper PBX switch
has been selected within the
NetLink Telephony Gateway.