Filter
Top Products
SpectraLink Corporation Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-E.doc Page 25
5. Testing a Wireless Telephone
Verify proper registration and operation of each Wireless Telephone by performing the
following tests on the Wireless Telephone in an active wireless area.
1. Power on the Wireless Telephone by pressing
Power On. You will see a
series of messages displayed as the Wireless Telephone acquires the system.
The Wireless Telephone should display the user extension or dashes if no
extension is programmed. Any error messages should clear.
2. Press the
Start Call key. The extension number should clear and you should
hear dial tone. On some digital systems, depending on how the telephone
system is programmed, you may have to select a line to get dial tone. Place a
call and listen to the audio quality. End the call by pressing the
End Call key.
3. Place a call to the Wireless Telephone and verify ring, answer, clear transmit,
and clear receive audio.
4. Use the
FCN key to verify all softkey programmed features on the Wireless
Telephone. Use the
MENU key and scroll through the Shortcut Menu. Ensure
the features displayed on the Shortcut Menu match those displayed in the
softkey function display area.
5. Press the
End Call key. Any line indicators should turn off and the extension
number display will return.
If any of these steps fails to operate as described, refer to the Troubleshooting section for
corrective action.