Filter
Top Products
SpectraLink Corporation Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-E.doc Page 32
8.5 Wireless Telephone Status Messages
Wireless Telephone status messages provide information about the NetLink e340 and
i640 Wireless Telephone's communication with the access point and host telephone
system. The following table summarizes the status messages, in alphabetical order.
Message Description Action
3 chirps (audio) Wireless Telephone is not able to
communicate with the best AP,
probably because that AP has no
bandwidth available.
None. This is only a warning, the
call will handoff to the best AP
once it becomes available.
(battery icon),
Low Battery,
beep (audio)
Low battery In call: the battery icon displays
and a soft beep will be heard when
the user is on the Wireless
Telephone and the battery charge
is low. User has 15–30 minutes of
battery life left.
The Battery Pack can be changed
while the call is still in progress. Do
not press End Call. Quickly
remove the discharged battery and
replace with a charged battery,
power on the Wireless Telephone,
and press Start Call to resume the
call in progress.
Not in call: The battery icon
displays whenever the Battery
Pack charge is low The message
Low Battery and a loud beep
indicate a critically low battery
charge when user is not on the
Wireless Telephone. The Wireless
Telephone will not work until the
Battery Pack is charged.
Battery Failure The Battery Pack is not functioning. Replace the Battery Pack with a
new or confirmed SpectraLink
Battery pack. Any non-SpectraLink
Battery Packs will not work.
Charging … The Wireless Telephone is charging
in the Desktop Charger
No action needed
Charge Complete The Wireless Telephone is now fully
charged
No action needed
Checking Code Wireless Telephone is contacting the
Download Master to determine if it
has a newer version of software that
should be downloaded.
None, this message should only
last for approximately one second.
If message remains displayed,
power off and contact customer
support for a replacement phone.