Filter
Top Products
SpectraLink Corporation Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-E.doc Page 33
Message Description Action
DHCP Error (1-4) DHCP Error 1 The Wireless Telephone cannot
locate a DHCP server. It will try
every 4 seconds until a server is
located.
DHCP Error 2 The Wireless Telephone has not
received a response from the
server for a request for an IP
address. It will retry until a server is
found.
DHCP Error 3 The server refuses to lease the
Wireless Telephone an IP address.
It will keep trying.
DHCP Error 4 The server offered the Wireless
Telephone a lease that is too short.
The minimum lease time is 10
minutes but SpectraLink engineers
recommend at least one hour
minimum lease time. The Wireless
Telephone will stop trying.
Reconfigure the server and power
cycle the Wireless Telephone.
Erase Failed Download process failed to erase the
memory in the Wireless Telephone.
This operation will retry.
Operation will retry but may
eventually report the error "int.
error: 0F". Power cycle the phone.
Erasing Memory Wireless Telephone has determined
that a download should occur and is
erasing the current software from
memory. This message also displays
a progress bar. When the progress
bar fills the display line the erase
operation is complete.
None. When the progress bar fills
the display line the erase operation
is complete.
Do not turn the Wireless
Telephone off during this
operation.
Internal Err. # # The Wireless Telephone has
detected a fault from which it cannot
recover.
OE = Error while writing the Flash
(return Wireless Telephone to
factory)
OF = No functional code (contact
SpectraLink Technical Support)
Record the error code so it can be
reported.
Turn the Wireless Telephone off
then on again.
If error persists, try registering a
different Wireless Telephone to
this telephone port.
If error still persists, contact
SpectraLink Technical Support and
report the error.
Multiple GW regs The Wireless Telephone has
discovered more than one
Telephony Gateway that is
configured with the Telephone’s
MAC address.
Check each NetLink Telephony
Gateway for the Wireless
Telephone’s MAC address on the
Telephone Line Configuration
screen. Delete any duplicate
entries leaving only one entry on
the correct Telephone Gateway
and port for this Wireless
Telephone.