Filter
Top Products
SpectraLink Corporation Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-E.doc Page 14
3. NetLink e340 and i640 Wireless
Telephone Configuration
Prior to configuring a NetLink e340 or i640 Wireless Telephone, it must be associated
with one and only one line on one of the NetLink Telephony Gateways. Then it must be
configured per the instructions in this section. The following instructions assume that the
Wireless Telephone has been properly associated with a line on a NetLink Telephony
Gateway. See NetLink Telephony Gateway: Setup and Maintenance: Telephone Line
Configuration for additional information. While Wireless Telephones are being
associated, the system will continue normal operation.
Use the Wireless Device Planning Worksheets filled out by the network or system
administrator to be sure you are correctly assigning telephone parameters.
3.1 The Admin Menu
The Admin menu contains configuration options that are stored locally (on each Wireless
Telephone). Every Wireless Telephone is independently configured and if the default
settings are not desired, the admin options must be set in each Wireless Telephone
requiring different settings.
Opening the Admin Menu
1. With the Wireless Telephone powered OFF, simultaneously press and hold the
Power On and Power Off keys.
2. Release the Power On key, wait for a single beep, then release the Power Off
key. The first option on the Admin menu displays.
If an admin password has been set, the display will require its entry before
opening the Admin menu. If no password is set, the display will proceed
directly into the Admin menu.
Entering and editing Admin Menu options
An asterisk (*) next to an option indicates that it is selected. The default settings are
shown in the table below with an * prior to the option. Use the
Up, Down, and Select
side buttons and the softkeys to navigate and select:
Up/Down buttons: display previous/next menu item.
Select button: selects the menu item or option.
OK softkey selects the menu item or option.
Save softkey: saves the entry.
Bksp softkey: backspaces to allow editing of entry.
Cncl softkey: cancels edit and returns to previous menu level.
Up softkey: returns to previous menu level.
Exit softkey: exits the menu (at the top level).
End Call key: exits to standby state (from any level)