Filter
Top Products
70 | Section 5
Type ‘help <command>’ to get specic help about a command.
Type ‘help *’ to get a short list of commands.
Type ‘help **’ to get a detailed list of commands.
Type ‘help <chars>*’ to get a list of commands starting with
<chars>.
‘#’ starts a decimal number, ‘%’ a binary number, ‘$’ a hex number.
Current number base is 16.
Separate multiple commands on a line by ‘::’.
List of available commands:
? CPC acc autoans bootstat bye call cidalert csinfo daa daacheck dd
disc
dmr dmw droponcptd fpkey gpio
help hookash hybrid isdn isdnlog lawmode lcgood lcignore lcinfo
lcoffset
lcwait lines log login logon lw
mcheck meter minonhook mixpoll mr mw potscountry prio quit reboot
ringtimo
test ti tslot
For a description of a command, type ‘help’ or ‘?’ followed by the name of a command. Example:
>>? CPC <return>
Command....: CPC <time in msec>
Description: Specify the time in msec a loop current drop must last
before a far-end drop is recognized. When set to 0 then loop cur-
rent drops are not detected at all.
A particularly useful command is for ISDN logging. is turns the Nx12 into an ISDN proto-
col analyzer so you can see the communications between the Nx12 and the Telco network.
>>? Isdnlog <return>
? isdnlog
Command....: isdnlog <bitmask>
Description: Specify ISDN logging mode bitmask: b0=general logging,
b1=Layer2, b3=layer3 b4=IIEs, b5=raw packet, b6=Telesoft stack.
Usually, 0xF is a good choice.