Telos NX12 Cell Phone User Manual


 
TECHNICAL DATA & TROUBLESHOOTING | 85
Cause No. 38 - Net out of order
is cause indicates that the network is not functioning correctly and that the condition is likely
to last a relatively long period of time e.g. immediately re-attempting the call is not likely to be
successful.
Cause No. 39 – Permanent frame mode connection is out-of-service [Q.850 only]
is cause indicates a calls has been preempted due to the circuit being reserved for reuse.
Cause No. 40 – Permanent frame mode connection is operational [Q.850 only]
is cause indicates a calls has been preempted due to the circuit being reserved for reuse.
Cause No. 41 – Net problem, redial (Temporary Failure)
is cause indicates that the network is not functioning correctly and that the condition is not
likely to last a long period of time; e.g. the user may wish to try another call attempt almost
immediately. May also indicate a data link layer malfunction locally or at the remote network
interface or that a call was cleared due to protocol error(s) at the remote network interface.
Cause No. 42 – Net busy, redial (Switching Equipment Congestion)
is cause indicates that the switching equipment generating this cause is experiencing a period
of high traffic.
Cause No. 43 – Access/user information discarded
is cause indicates that the network unable to deliver user information (i.e user-to-user
information, low level compatibility or sub-address, etc) to the remote users as requested.
Cause No. 44 – No channel available (Requested circuit/channel not available)
is cause is returned when the circuit or channel indicated by the requesting entity cannot be
provided by the other side of the interface.
Cause No. 46 – Precedence call blocked [Q.850 only]
is cause is used to indicate that there are no pre-emptable circuits or that the called user is
busy with a call of equal or higher pre-emptable level.
Cause No. 47 – Resource unavailable/New Destination
is cause is used to report a resource unavailable event only when no other cause in the
resource unavailable class applies.
or
is cause is used to indicate that the original destination is unavailable and to invoke redirec-
tion to a new destination.
Cause No. 49 – QOS unacceptable
is cause is returned when the Quality of Service is unacceptable.
CLASS 1.3 (service or option not available)
Cause No. 50 – Requested facility not subscribed
e cause is used to report that the user cannot use this feature because s/he has not subscribed
to it.
Cause No. 51 – Bearer capability incompatible with service request
is cause indicates a user request for action was rejected because the action was incompatible
with the capability of the call.
Cause No. 52 – Outgoing calls barred
is cause indicates that because of call screening provided by the network, the calling user is
not permitted to make a call.