xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
269
enable erps
The default state is disabled.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable ERPS:
DGS-3627:admin# enable erps
Command: enable erps
Success.
disable erps
Purpose Used to disable the global ERPS function on a switch.
Syntax
disable erps
Description This command is used to disable the global ERPS function on a switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable ERPS:
DGS-3627:admin# disable erps
Command: disable erps
Success.
create erps raps_vlan
Purpose Used to create an R-APS VLAN on a switch.
Syntax
create erps raps_vlan <vlanid>
Description This command is used to create an R-APS VLAN on a switch. Only one R-APS VLAN should
be used to transfer R-APS messages.
Note: The R-APS VLAN must already have been created by the create vlan command.
Parameters
raps_vlan - Specifies the VLAN which will be the R-APS VLAN.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To create and ERPS R-APS VLAN:
