xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config vlan delete
specifies all of the ports between slot 1, port 3 and slot 2, port 4 −
in numerical order.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete ports 5-7 of module 2 of the VLAN v1:
DES-6500:4#config vlan v1 delete 2:5-2:7
Command: config vlan v1 delete 2:5-2:7
Success.
DES-6500:4#
config gvrp
Purpose Used to configure GVRP on the Switch.
Syntax
config gvrp [<portlist> | all] {state [enabled | disabled] |
ingress_checking [enabled | disabled] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
Description This command is used to configure the Group VLAN Registration
Protocol on the Switch. Configurable items include ingress
checking, the sending and receiving of GVRP information, and the
Port VLAN ID (PVID).
Parameters
<portlist> − A range of ports to configure GVRP for. The port list
is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4 −
in numerical order.
all − Specifies all of the ports on the Switch.
state [enabled | disabled] − Enables or disables GVRP for the
ports specified in the port list.
ingress_checking [enabled | disabled] − Enables or disables
ingress checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter
states the frame type that will be accepted by the Switch for this
function. Tagged_only implies that only VLAN tagged frames will
be accepted, while admit_all implies tagged and untagged frames
will be accepted by the Switch.
pvid – Specifies the default VLAN ID associated with the port.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
123
