xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
41
OSPF CONFIGURATION COMMANDS
The OSPF configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config ospf router_id <ipaddr>
enable ospf
disable ospf
show ospf
create ospf area
<area_id 0.0.0.
0-255.255.255.255> type [normal | stub {stub_summary [enabled | disabled] | metric <value 0-
65535>}]
delete ospf area
<area_id>
<area_id> type [normal | stub {stub_summary [enabled |
disabled] | metric <value 0-65535>}]
show ospf area
{<area_id>}
create ospf host_route
<ipaddr> {area <area_id> | metric <value 1-65535>}
delete ospf host_route <ipaddr>
config ospf host_route
<ipaddr> {area <area_id> | metric <value 1-65535>}
show ospf host_route <ipaddr>
create ospf aggregation
<area_id> <network
_address> lsdb_type summary {advertise [enabled | disabled]}
delete ospf aggregation
<area_id> <network_address> lsdb_type summary
config ospf aggregation
<area_id> <network_address> lsdb_type summary {advertise
[enabled | disabled]}
show ospf aggregation
<area_id>
show ospf lsdb
{area <area_id> | adv
ertise_router <ipaddr> | type [rtrlink | netlink | summary | assummary | asextlink]}
show ospf neighbor <ipaddr>
show ospf
virtual_neighbor
{<area_id> <neighbor_id>}
config ospf ipif
<ipif_name 12> {area <area_id> | priority <value 0-255> |
hello_interval <sec 1-65535 > | dead_interval <sec 1-65535> |
authentication [none | simple <password 8> | md5 <key_id 1-
255>] | metric <value 1-65535> state [enabled | disabled]
config ospf all
{area <area_id> | pr
iority <value> | hello_interval <1-65535 sec> | dead_interval <1-65535 sec> | authentication [none |
simple <password 8> | md5 <key_id 1-255>] | metric <value
1-65535> state [enabled | disabled]
show ospf ipif <ipif_name 12>
config ospf area
303
