xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config cpu access_profile
• vlan <vlan_name 32> − Specifies that the access profile will apply to
only to this VLAN.
• vlan <vlan_name 32> − Specifies that the access profile will apply to
only this VLAN.
• source_mac <macaddr> − Specifies that the access profile will apply
to this source MAC address.
• destination_mac <macaddr> − Specifies that the access profile will
apply to this destination MAC address.
• ethernet_type <hex 0x0-0xffff> − Specifies that the access profile will
apply only to packets with this hexadecimal 802.1Q Ethernet type
value in the packet header.
ip − Specifies that the Switch will look into the IP fields in each packet.
• source_ip <ipaddr> − Specifies that the access profile will apply to
only packets with this source IP address.
• destination_ip <ipaddr> − Specifies that the access profile will apply to
only packets with this destination IP address.
• dscp <value 0-63> − Specifies that the access profile will apply only to
packets that have this value in their Type-of-Service (DiffServ code
point, DSCP) field in their IP packet header
• icmp − Specifies that the Switch will examine the Internet Control
Message Protocol (ICMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will
apply to this ICMP type value.
• code <value 0-255> − Specifies that the access profile will
apply to this ICMP code.
• igmp − Specifies that the Switch will examine the Internet Group
Management Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will
apply to packets that have this IGMP type value.
• tcp − Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP source port in
their TCP header.
• dst_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP destination port
in their TCP header.
• protocol_id <value 0-255> − Specifies that the switch will examine the
Protocol field in each packet and if this field contains the value
entered here, apply the following rules.
• udp − Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this UDP source port in
their header.
• dst_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this UDP destination port
231
