xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
DES-6500:4#config radius delete 1
Command: config radius delete 1
Success.
DES-6500:4#
config radius
Purpose Used to configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
Description
The config radius command is used to configure the Switch’s
RADIUS settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server
settings can be entered on the Switch.
ipaddress <server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
auth_port <udp_port_number> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
<passwd 32> − The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can be
used.
Example usage:
To configure the RADIUS settings:
DES-6500:4# config radius 1 ipaddress 10.48.74.121 key dlink
Command: config radius 1 ipaddress 10.48.74.121 key dlink
Success.
DES-6500:4#
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
Syntax
show radius
Description
The show radius command is used to display the current
RADIUS configurations on the Switch.
Parameters None.
Restrictions None.
203
