xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the
Switch.
Syntax
show traffic_segmentation <portlist>
Description
The show traffic_segmentation command is used to display the
current traffic segmentation configuration on the Switch.
Parameters
<portlist> − Specifies a range of ports for which the current traffic
segmentation configuration on the Switch will be displayed. The port
list is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest slot
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies slot
number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4 − in
numerical order.
Restrictions The port lists for segmentation and the forward list must be on the
same switch.
Example usage:
To display the current traffic segmentation configuration on the Switch.
DES-6500:4#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- ----------------------------
1:1 1:1-1:10,2:1-2:12
1:2 1:1-1:10,2:1-2:12
1:3 1:1-1:10,2:1-2:12
1:4 1:1-1:10,2:1-2:12
1:5 1:1-1:10,2:1-2:12
1:6 1:1-1:10,2:1-2:12
1:7 1:1-1:10,2:1-2:12
1:8 1:1-1:10,2:1-2:12
1:9 1:1-1:10,2:1-2:12
1:10 1:1-1:10,2:1-2:12
1:11 1:1-1:10,2:1-2:12
1:14 1:1-1:10,2:1-2:12
1:12 1:1-1:10,2:1-2:12
1:13 1:1-1:10,2:1-2:12
1:15 1:1-1:10,2:1-2:12
1:16 1:1-1:10,2:1-2:12
1:17 1:1-1:10,2:1-2:12
1:18 1:1-1:10,2:1-2:12
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
239
