xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
download
increment − Allows the download of a partial switch
configuration file. This allows a file to be downloaded that will
change only the Switch parameters explicitly stated in the
configuration file. All other switch parameters will remain
unchanged.
Restrictions The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
Example usage:
To download a configuration file:
DES-6500:4#download cfg_to TFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_to TFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration............. Done.
DES-6500:4#
Due to a backward compatability issue, when a user upgrades to R3 firmware (3.00-B29),
all settings previously configured for any ACL function (CPU ACL included) on the Switch
will be lost. We recommend that the user save a configuration file of current settings before
upgrading to R3 firmware.
upload
Purpose Used to upload the current switch settings or the switch history log
to a TFTP server or a CompactFlash memory card.
Syntax
upload [cfg_toTFTP | log_toTFTP] <ipaddr> <path_filename 64>
Description This command is used to upload either the Switch’s current settings,
the Switch’s history log or firmware to a TFTP server or a
CompactFlash memory card.
Parameters
cfg_toTFTP − Specifies that the Switch’s current settings will be
uploaded to the TFTP server.
log_toTFTP − Specifies that the Switch’s current log will be
uploaded to the TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced
by the uploaded file from the Switch.
Restrictions The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
Example usage:
To upload a configuration file:
53
