TELUS Mobility™
8 www.telusmobility.com
MODEM CONFIGURATION
In this chapter, you will learn how to set up your windows components, install the iDEN
Packet Data Applet, and
configure the iR1200 modem to operate with the iDEN
network.
Windows Configurations
Windows 95/98/ME
Windows NT/2000
Windows XP
Page 8
Page 8
Page 9
Page 10
Installing iDEN
Packet Data Applet
Minimum Requirements
Before You Begin
Download iDEN
Packet Data Applet
Page 11
Page 11
Page 11
Page 11
Manual Modem Configuration
Windows 95/98/ME
Windows NT
Windows 2000
Windows XP
Page 21
Page 21
Page 22
Page 24
Page 26
Modem Profiles and Settings Page 27
Configuring with AT Commands Page 28
Windows Configurations
Windows 95/98/ME
Verify Dial-Up Networking
The following steps describe how to verify if dial-up networking is installed on your computer.
1. From your desktop, double-click the My Computer icon to open the My Computer window.
2. Double-click the Dial-Up Networking icon to open the Dial-Up Networking window.
3. Double-click the Make New Connection icon. The Make New Connection window should appear, indicating that dial-
up networking is installed.
4. Click Cancel to close the Make New Connection window.
Verify TCP/IP Protocol Installation
The following steps describe how to verify if TCP/IP Protocol and Dial-up Adapter are installed on your computer.
1. From your desktop, double-click the My Computer icon to open the My Computer window.
2. Double-click the Control Panel icon to open the Control Panel window.
3. Double-click the Network icon to open the Network window.
4. Scroll down the list to find TCP/IP Dial-Up Adapter.
5. If you see TCP/IP à Dial-Up Adapter in the list, click OK; you have TCP/IP installed and can proceed with
installation.
6. If you do not see TCP/IPà Dial-Up Adapter in the list, you will need to add the TCP/IP protocol. Click Add and
