iR1200 Modem
www.telusmobility.com 37
Parameter
Values:
A PIN is stored as a series of alphanumeric
characters, with a maximum length of 8 characters. If
more than 8 characters are set as a PIN, only the first
8 are recognized.
Packet Data Sleep Timer [AT+ws175]
This timer controls the length of time the DCE stays on a packet channel though no traffic is actively being transferred.
Command +WS175
Action
AT+ws175=
Query
AT+ws175?
Range
AT+ws175=?
Parameter
Values:
0 = Disable sleep timer
5-255 = Seconds before sleeping
10 = Default value
SLIP MTU [AT+wv312]
This setting specifies the Maximum Transmitted Unit used by SLIP connections. (PPP Connections negotiates this value).
Command +WV312
Action
AT+wv312=<MTU>
Query
AT+wv312?
Range
AT+wv312=?
Parameter
Values:
68-1500 = MTU Value Range
1006 = Default Value
Select Mobile IP Client [AT+wv300]
This parameter activates/deactivates the Mobile Node client in the DCE. The mobile host can operate in two modes to
access the iDEN
packet data network.
Command +WV300
Action
AT+wv300=<MIP Mode>
Query
AT+wv300?
Range
AT+wv300=?
Parameter
Values:
0 = Activate Mobile Node in DCE.
1 = Deactivate Mobile Node in DCE.
Mobile IP Authentication Key [AT+wv301]
The iDEN
network uses the MIP Authentication Key to verify the authenticity of the DCE with the Home Agent. The DCE
and the Home Agent must have identical values for this shared secret key for the DCE to satisfy the authentication process.
NOTE: This command is applicable only when the Mobile IP Client in the DCE is activated.
Command +WV301
Action
AT+wv301<”key”>
Query
