TELUS Mobility™
10 www.telusmobility.com
The following steps describe how to check that TCP/IP is in fact installed, and if necessary add the TCP/IP protocol.
NOTE: This may require that you contact your IT Representative or System Administrator.
1. From your desktop, select StartàSettingsàNetwork and Dialup ConnectionsàLocal Area Connection. The
Local Area Connection window opens.
2. Click the Properties button on the Local Area Connection window.
3. Is the Internet Protocol listed under the Components listing?
4. If the Internet Protocol is not listed, click the Install button. The Select Network Component Type window opens.
5. Under Network Component Type listing, highlight Protocol and click Add.
6. The Select Network Protocol window opens. Under Network Protocol listing, highlight Internet Protocol and
click OK.
7. The installation will now begin — IMPORTANT: If prompted, do NOT select restart.
Installing the Dial-Up Adapter
The Dial-Up Adapter may not have been included in the standard installation. The following steps describe how to check that
TCP/IP is in fact installed, and if necessary add the TCP/IP protocol.
NOTE: This may require that you contact your IT Representative or System Administrator.
1. Select Startà SettingsàControl Panel. The Control Panel window opens. Double click on Network and Dial up
Connections.
2. The Network and Dial up Connections window opens. Double click on Make New Connection, which brings up the
connection wizard. Click Next.
3. Select I want to set up my Internet connection manually, then click on Next.
4. Select I connect through a phone line and a modem then click on Next.
5. Enter the new phone number as follows:
• Packet Data enter: s=2
• Circuit Switched enter: ISP Phone Number
• Click on the Advanced button.
6. The Advance Connection Properties window opens. On the Connection tab, select PPP and for Logon procedure
select None.
7. Click on the Addresses tab. Select My ISP automatically provides... Click on OK to return to the phone number
screen. Click on Next to continue.
8. Enter your username and password then click Next.
9. Enter a connection name such as “iR1200 Modem” or “iDEN Connection” and then click Next.
10. Select No and click Next. Click on Finish to complete the setup.
NOTE: If it is determined that your computer does not have dial-up networking, please proceed to the
“Manual Modem Configuration” for instructions on how to install dial-up networking.
Windows XP
!
IMPORTANT: Dial-up Networking is installed on Windows ME,
2000 and XP automatically. You will only need to verify that the
modem has been installed and is working correctly to create a
dial-up connection.
