TELUS Mobility™
28 www.telusmobility.com
Command Syntax
ATZ0
Expected Return Code(s)
OK
Step 3 – Save new setting as default profile.
AT Command
Save User Default Configuration
Command Syntax
AT&W2
Expected Return Code(s)
OK
Restore Factory Defaults [AT&F]
To ensure a clean configuration process, you should restore the current values to their factory default values by applying the
following.
AT Command
Restore Factory-Default Configuration
Command Syntax
AT&F
Expected Return Code(s)
OK
Activate DTR Monitoring [AT&D2]
The DCE does not monitor the DTR line of the DTE/DCE physical connection. This is the default factory setting. To activate
DTR monitoring in the DCE, you must apply the following command.
AT Command
DTR Behavior
Command Syntax
AT&D2
Expected Return Code(s)
OK
Activate DCD Management [AT&C1]
The factory default for the modem keeps the Data Carrier Detect (DCD) line of the computer-to-modem physical connection
active at all times. Some communication programs monitor this line to determine the status of the connection. To promote
compatibility with these programs, enable DCD management in the modem.
AT Command
DCD Behavior
Command Syntax
AT&C1
Expected Return Code(s)
OK
Select iDEN
Packet Wireless Data [AT+WS46=24]
The iR1200 modem supports multiple wireless data formats. Select the desired data service by applying the following command.
AT Command
Select WDS-side stack
Command Syntax
AT+WS46=24
Expected Return Code(s)
OK
Select SLIP [AT+WS45=3] or PPP [AT+WS45=4]
By default, the modem attempts to establish a PPP connection. To specify the type of connection the modem will establish,
apply the following command.
AT Command
Select computer-side stack
Command Syntax
AT+WS45=4 (PPP)
AT+WS45=3 (SLIP)
Expected Return Code(s)
OK
