iR1200 Modem
www.telusmobility.com 11
Installing iDEN
Packet Data Applet
Minimum Requirements
To run the installation program, you will need the following:
• An IBM
compatible PC with:
o 586 (or higher) processor
o Microsoft
Windows 95, 98, NT or 2000, XP
o Minimum 8 MB of addressable RAM
o 3 MB free hard-disk space
• Recommended: Mouse or compatible pointing device
• Communication software
• Standard Internet browser (such as Internet Explorer or Netscape)
• An active account with TELUS (for connection to the iDEN
network)
Before You Begin
Windows must have a Dial-up Networking Version 1.3 or later and the TCP/IP protocol Installed.
NOTE: If the version of your Dial-up Networking is earlier than v1.3, please consult your Systems Administrator.
!
IMPORTANT: Before proceeding, please check that your computer
has a network card or security program that prevents IP address
changes.
• Windows Dial-Up Networking version 1.3 or higher installed (refer to the “Manual Modem Configuration” chapter in
this guide for installation instructions)
• TCP/IP installed (refer to the “Setup Windows Components” chapter in this guide for installation instructions)
• Dial-Up Adapter installed (refer to the “Setup Windows Components” chapter in this guide for installation instructions)
Download iDEN
Packet Data Applet
The iDEN
Packet Data Applet configures your computer to receive packet data services. It also monitors the service and
provides service status information such as battery status and signal strength.
Windows 95/98/ME
The following steps describe how to download and install the iDEN
Packet Data Applet on a Windows 95/98/ME operating
system.
1. You can access the link to the iDEN
Packet Data Applet by going to www.elutions.com/wireless website.
2. From the eLutions wireless website, click on the Product Support link, to navigate to the Product Support page.
3. From the Product Support page, scroll down and click on the iDEN
Packet Data Applet link.
4. The iDEN
Packet Data Applet page appears.
5. From the iDEN
Packet Data Applet screen, click on the Download button next to the iDEN
Packet Data Applet
section to download the software
