TELUS Mobility™
36 www.telusmobility.com
Local Data Rate [AT+ipr]
This numeric extended-format parameter specifies the data rate between the DTE and the DCE.
Command +IPR
Action
AT+ipr=<rate>
Query
AT+ipr?
Range
AT+ipr=??
Parameter
Values:
0 = Automatic detection on baud rate, data framing
300 = Transmission speed in bits per second.
2400 = Transmission speed in bits per second.
4800 = Transmission speed in bits per second.
9600 = Transmission speed in bits per second.
19200 = Transmission speed in bits per second.
38400 = Transmission speed in bits per second.
57600 = Transmission speed in bits per second.
115200 = Transmission speed in bits per second.
Lock/Unlock the DCE [AT+wclk]
When the DCE is locked, communication over the serial port to the modem is suspended.
NOTE: If the PIN was removed (by setting its value to the empty string (“ ”), the DTE must still specify the PIN,
represented by the empty string.
Command +WLCK
Action
AT+wclk=<LockStatus>, <PIN>
Query
Range
AT+WCLK=?
Parameter
Values – Lock
Status:
0 = Unlock the DCE
1 = Lock the DCE
PIN
A PIN is stored as a series of alphanumeric characters,
with a maximum length of 8 characters. If more than
8 characters are set as a PIN, only the first 8 are
recognized.
Change the DCE’s PIN [AT+wcpn]
This command sets the PIN that locks or unlocks the DCE.
NOTE: You must specify the desired PIN, as well as the current PIN. The factory-default PIN is the “empty string” or a
value of “ ”.
Command +WCPN
Action
AT+wcpn=<newPIN>, <oldPIN>
Query
Range
AT+wcpn=?
