Filter
Top Products
N
o
t
f
o
r
C
o
m
m
e
r
c
i
a
l
U
s
e
E
r
i
c
s
s
o
n
M
o
b
i
l
e
C
o
m
m
u
n
i
c
a
t
i
o
n
s
A
B
Accessories 99
Other Handsfree-Related Settings
Apart from the settings mentioned above, each of the settings below can be
specified separately when you have your R250s PRO connected to handsfree
equipment and when you use the phone as a handheld unit:
• Ring level
• Earpiece volume
• Ring type
• Display light
This means that if you make one of these settings when the phone is
connected to handsfree equipment, the settings when it is handheld are not
affected and vice versa.
To change a setting
1. Connect the phone to the handsfree equipment.
2. Change the setting according to the instructions in the chapter “Personal-
izing Your Phone” on page 46.
The desk/wall stand for the R250s PRO serves both as a charger and a holder
for the phone. When the battery runs low just place the phone in the desk/wall
stand to charge it (the charger must be connected to the desk/wall stand).
The desk/wall stand can be placed on e.g. a table or attached to the wall. The
desk/wall stand consists of two pieces that can be separated (see pictures).
You need to separate and rotate the two pieces to change between desk and
wall stand modes.
Connecting the charger
DESK/WALL STAND
1. Place the desk/wall stand on a
table or attach it to the wall.
2. Connect the charger to the mains.
3. Connect the other end of the
cable to the desk/wall stand. The
flash symbol on the plug must
face upwards.
4. Place the phone in the desk/wall
stand to charge the phone.