Filter
Top Products
Chapter 1 — Using the Computer
751G Color Mobile Computer User’s Manual 5
If you have at least one device in your 751G (radio, scanner, or imager), the
battery power fail level is set so that after the system shuts down in a low
battery condition, there is still sufficient charge to allow the unit to remain
configured, keep proper time, and maintain DRAM (Dynamic Random
Access Memory) for at least 72 hours at room temperature if the main
battery remains in the mobile computer.
The configuration and time are lost if:
• The battery discharges beyond this level.
• The battery is removed when the computer is not in suspend mode.
• A cold-boot (reset) is performed on the computer.
Installing and Charging the Battery
Make sure you fully charge the battery before you use your 751G. To
charge the battery, you need to install it in the 751G.
1 Remove the two thumb screws on the connector cover to release the
hand strap and back cover.
2 Slide the bottom of the strap forward to release it from the retaining slot.
3 Tilt, insert, and place the battery into the compartment. Make sure the
battery compartment latch clicks in place to ensure the battery is secure.
4 Insert your 751G into its single dock for charging.
Thumb screws
Retaining slot
Battery compartment latch
Battery compartment
Battery pack