Filter
Top Products
69SAR
SAR
European Union (R&TTE) and
international (ICNIRP)
INFORMATION ON RF EXPOSURE /
SPECIFIC ABSORPTION RATE (SAR)
THIS MODEL MEETS INTERNATIONAL
GUIDELINES FOR EXPOSURE TO RADIO
WAVES
Your mobile device is a radio transmitter
and receiver. It is designed not to exceed the
limits for exposure to radio waves
recommended by international guidelines.
These guidelines were developed by the
independent scientific organization
ICNIRP and include safety margins
designed to assure the protection of all
persons, regardless of age and health.
The guidelines use a unit of measurement
known as the Specific Absorption Rate, or
SAR. The SAR limit for mobile devices is
2 W/kg and was adopted into the European
Standard EN 50360 and into other national
standards. The CE mark demonstrates that
the EU requirements are met.
The highest SAR value for this device when
tested at the ear was 0.509 W/kg
1
. As
mobile devices offer a range of functions,
they can be used in positions other than the
head, such as on the body. In this case, at
data transfer (GPRS) a separation distance
of 1.5 cm is required.
As SAR is measured utilizing the device's
highest transmitting power, the actual SAR
of this device while operating is typically
below that indicated above. This is due to
automatic changes to the power level of the
device to ensure it only uses the minimum
level required to reach the network.
The World Health Organization has stated
that present scientific information does not
indicate the need for any special
precautions for the use of mobile devices.
They note that if you nevertheless want to
reduce your exposure then you can do so by
limiting the length of calls or using a
'hands-free' device to keep the mobile
phone away from the head and body.
Additional Information can be found on the
website of the World Health Organization
(www.who.int/emf).
Maximum SAR measurement for
FCC requirements
Head: 0.741 W/Kg (1g)
Body: 1.06 W/Kg (1g)
Co-location of GSM and WLAN
Head: 0.79 W/Kg (1g)
Body: 1.07 W/Kg (1g)
Battery and charger
specifications
Charger
Input: 100-240V 50/60 Hz
Output: 5.2V
Battery
Voltage: 3.7V 900mAh
1 The tests are carried out in accordance with
international guidelines for testing.