Kyocera K612 Cell Phone User Manual


 
User Guide for Switch_Back v
Resetting the phone
If the screen seems frozen and the keypad does
not respond to keypresses, reset the phone by
completing the following steps:
1. Remove the battery door.
2. Remove and replace the battery.
If the problem persists, return the phone to the
dealer for service.
Accessories
Use only Kyocera-approved accessories with
Kyocera phones. Use of any unauthorized
accessories may be dangerous and will invalidate
the phone warranty if said accessories cause
damage or a defect to the phone.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Virgin Mobile’s network controls the power of the
RF signal. This power level can range from 0.006
to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure
guidelines with safety levels for hand-held wireless
phones. These guidelines are consistent with the
safety standards previously set by both U.S. and
international standards bodies in the
following reports:
ANSI C95.1 (American National Standards
Institute, 1992)
NCRP Report 86 (National Council on
Radiation Protection and Measurements, 1986)
ICNIRP (International Commission on
Non-Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by
these reports and the FCC guidelines.
E911 mandates
Where service is available, this handset complies
with the Phase I and Phase II E911 Mandates
issued by the FCC.
Battery and charger specifications
Kyocera Wireless Corp.
10300 Campus Point Drive, San Diego, CA 92121
U.S.A.
Visit us at www.kyocera-wireless.com
Charger Input Output
CV90-G2610 120 VAC / 60 Hz 5.2 V 400 mA
CV90-K0259 100-240 VAC / 50/60 Hz 4.5 V 1.2 A
CV90-K0261 100-240 VAC / 50/60 Hz 4.5 V 600 mA
Standard Battery (5 mm):
CV90-P4200: 3.7 V / 900 mAh
Extended Battery (10 mm):
CV90-P3002: 3.7 V / 1600 mAh
82-N8757-1EN.book Page v Wednesday, April 26, 2006 10:47 AM