Filter
Top Products
User Guide for Switch_Back 1
1GETTING STARTED
Finding your phone's serial
number
To activate your Virgin Mobile account, you need
your phone's serial number. To locate the number:
1. Turn your phone off.
2. Hold your phone face up in your left hand.
3. Insert your right thumbnail into the groove on
the right side of the phone and push down to
pop the back cover off.
4. Remove the battery by pulling back on the top
edge of the battery.
5. Your phone's serial number (the ESN) is
located just below the first barcode inside the
phone, next to the letter "D." It is an
11-digit number.
6. Write down the ESN.
Installing the battery
Your Switch_Back phone comes with a removable
lithium ion (LI Ion) battery.
Fully charge the
battery before using the phone.
To install the battery:
1. Remove the back cover
by holding the phone
face up in your left
hand.
2. Insert your right
thumbnail into the
groove on the right side
of the phone and push
down to pop the back
cover off.
3. Place the battery in the
phone casing the metal
contacts of the battery
touching the metal
contacts of the phone.
4. Replace the back cover
by sliding the notches into the opening on the
left side of the phone.
5. Snap the back cover into place
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter to
the jack on the bottom of
the phone. Do not force
the AC adapter into the
jack. Make sure the
arrow is face up
as shown.
2. Plug the adapter into a wall outlet.
82-N8757-1EN.book Page 1 Wednesday, April 26, 2006 10:47 AM