Filter
Top Products
NEC MH150/MH160 Wireless Handset Configuration 3-15
NEC MH150/MH160 Mobile Handset Administration Guide - Revision 2
and 802.11 mode are listed. Navigate to the desired level and
press NavOK. This sets the transmit power level and exits the
Regulatory Domain menus. The Network Setup menu will
again display.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. The site
survey starts running immediately upon selecting this option. See
“Diagnostic Tools” on page 9-1 for more information about site survey.
Diagnostics Mode
Diagnostics can be enabled or disabled. See “Diagnostics Enabled” on
page 9-4 for a detailed explanation of the Diagnostics mode options.
Syslog Mode
See “Syslog Mode” on page 9-8 for a detailed explanation of the Syslog
mode options.
Error Handling Mode
The Error Handling mode determines how the handset will behave
when an error occurs. The Halt on Error option will cause the handset
to stop operating if an error message is received. Unless the error is a
fatal one, normal operation may be resumed by power-cycling the
handset. The Restart on Error option will cause the handset to make
every effort to reboot quietly and quickly to standby mode. In either
scenario, a call in progress will be lost.
Error detail may be shown on the display, captured by the syslog server
and may also be available for downloading with the Handset
Administration Tool.
Restore Defaults
The Restore Defaults option will set all user and administrative
parameters except Telephony Protocol to their factory defaults.