Filter
Top Products
7-12 Using the MH150/MH160 Mobile Handset
NEC MH150/MH160 Mobile Handset Administration Guide - Revision 2
Silence the ringing
Press the END key to silence the external speaker ring and convert to in-ear
speaker ringing.
External speaker ringing will resume when the next incoming call is received
while the handset is in standby mode.
Change the ring volume
Press the up/down volume buttons on the side of the handset during ringing, or
while
the handset is in standby mode.
Adjust the speaker volume
While speakerphone is active, press the up/down volume buttons on the side of
the handset during the call.
Adjust the headset volume
While the headset is plugged in, press the up/down volume buttons on the side
of the handset during the call.
Mute/Unmute a call
Press the Mute softkey.
When the handset is muted, the audio flowing icon
changes to the audio
receive-only icon
. Press the Mute softkey again to restore audio pickup.
End a call
Press the End softkey to maintain the active mode and
view the active calls.
Press the END key on the keypad to return to the standby mode.
Change the profile
Press the Prof softkey and use the Nav keys to select a new profile while in
standby mode. The selected profile is marked with an asterisk (*).
Open the Config menu Press the Cfg softkey from standby mode.
Turn on the backlight
The backlight comes on when any key is pressed or when there is an incoming
call, and stays on for 10 seconds. It turns off if another key is not pressed within
that period.
Resume a call on hold from
standby.
Press the Rtv softkey. If more than one call is on hold, use the Nav ◄► keys
to select the call you wish to resume and press the Rtv softkey or NavOK.
Open the Phonebook
Press the Phbk softkey from standby mode. The phonebook may also be
opened by pressing the Save softkey when it appears in a call log or during
predialing.
The phonebook list is sorted alphabetically.
The <new> option appears until the maximum number of entries (20) has been
entered.
View system speed dial
number
If the system speed dial key has been programmed, it
will be listed as the first
entry with a close bracket (>) as the first character. Only the system administrator
may change this entry.
Search for a phonebook entry
Use Nav ▲ and Nav ▼ to scroll through the names or press the keys
corresponding to the first letters of the name. Use Nav ◄ and Nav ► to edit the
search characters as needed.
If you want to… Then…