Filter
Top Products
9-8 Diagnostic Tools
NEC MH150/MH160 Mobile Handset Administration Guide - Revision 2
EAP error code would be 5000. Refer to [1]) http://www.ietf.org/
rfc/rfc2759.txt section 6, [2] http://ietfreport.isoc.org/all-ids/draft-
zhou-emu-fast-gtc-02.txt section 2.
E A P E r r C N t x x x x x
L a s t E A P E R C o d e x x x x
Syslog Mode
A syslog server must be present on the network in order for the handset
to send the log messages and have them saved. The syslog server will
be found with DHCP option 7 if the handset is using DHCP. If static
addresses are configured, the syslog server's IP address can be
configured statically in the Admin menu.
If the syslog server address is blank (000.000.000.000 or 255.255.255.255) or the
handset is using DHCP and no option 7 is received from the DHCP server, the
handset will not send any syslog messages.
Admin menu options:
• *D
isabled - turns syslog off.
• Er
rors - causes the handset to log only events that we consider to be
an error (see below).
• Even
ts - logs all errors plus some other interesting events (see
below).
• Full
- logs all the above plus a running stream of other quality
information (see below).
Table 9-1 lists the syslog messages and which level of logging will
produce them.
NOTE