Filter
Top Products
7-8 Using the MH150/MH160 Mobile Handset
NEC MH150/MH160 Mobile Handset Administration Guide - Revision 2
to the waiting call by selecting Xfer/Conf/Wait from the FCN menu on
his handset. This places user-B's original call on hold and connects him
to user-A. This mode is supported on the Univerge NEAX 2400 IPX and
Univerge NEAX 2000 IPS.
Using the Call-Waiting access code
When a user knows that the extension he intends to call is busy even
before the call is placed, he may issue a Wait request by dialing the Call-
Waiting access code directly. When the special dial tone sounds, he dials
the busy extension's number. A call-waiting tone signals user-B that
there is a call waiting, while user-A hears the call-waiting ring-back
tone. User-B may switch to the waiting call as described above. This
mode is supported on the Univerge NEAX 2400 IPX.
PBX-activated Call-Waiting
The third mode of Call-Waiting is activated automatically by the PBX
without any action required from the user. In this mode, when user-A
places a call and the number is busy, the PBX automatically plays the
call-waiting-tone to user-B while user-A hears the call-waiting ring-back
tone. User-B may switch to the waiting call as described above. This
mode is supported on the Univerge NEAX 2400 IPX and Univerge NEAX
2000 IPS.