Filter
Top Products
• Prompt password — Select Yes to enter your
password each time you log into a server or No to save
the password in your device memory and automate
the login.
• Password — Enter your password if required by the
service provider. The password is often case-sensitive
and provided by the service provider.
• Authentication — Select Secure to send your
password always encrypted, or Normal to send your
password encrypted when possible.
• Homepage — Enter the web address of the page you
want to display as the home page when you use this
access point.
4. After defining the settings, select Options > Advanced
settings to define the advanced settings or Back to save
the settings and exit.
Advanced internet access point
settings for packet data (GPRS)
Select Menu > Tools > Settings > Connection > Access
points.
After setting up a basic internet access point for packet data
(GPRS), select Options > Advanced settings, and define the
following advanced settings:
• Network type — Select IPv4 or IPv6 as the internet
protocol type. The internet protocol defines how data is
transferred to and from your device.
• Phone IP address — Enter the IP address of your device.
Select Automatic to have the network provide the device
IP address. This setting is shown only if you select
Network type > IPv4.
• DNS address — Select Primary DNS address and
Secondary DNS address and enter their IP addresses, if
required by your service provider. Otherwise, the name
server addresses are provided automatically.
• Proxy server address — Enter the address of the proxy
server. Proxy servers are intermediate servers used by
some service providers between a browsing service and
its users. These servers may provide additional security
and speed up access to the service.
Set up an access point for WLAN
manually
1. Select Menu > Tools > Settings > Connection >
Access points.
2. Select Options > New access point to create a new
access point, or select an existing access point from the
list and then Options > Duplicate access point to use
the access point as a basis for the new one.
3. Define the following settings.
• Connection name — Enter a descriptive name for the
connection.
• Data bearer — Select Wireless LAN.
• WLAN network name — To enter the service set
identifier (SSID), that is, the name that identifies the
specific WLAN, select Enter manually. To select the
network from the WLANs in range, select Search for
networks.
© 2007 Nokia. All rights reserved. 99