Filter
Top Products
Basic Operations
16
Basic Operations
Switch the phone on
Press and hold the
power key.
If the phone asks for a
PIN code, UPIN code, or
lock code, enter the code
(displayed as ****), and
select OK. The PIN or
UPIN code is usually supplied with the SIM or USIM card.
The factory setting for the lock code is 12345.
Your device has a built-in antenna.
Note: As with any other
radio transmitting device,
do not touch the antenna
unnecessarily when the
device is switched on.
Contact with the antenna
affects call quality and may
cause the device to operate
at a higher power level than
otherwise needed. Avoiding contact with the
antenna area when operating the device optimizes
the antenna performance and the battery life.
Clock
Options in Clock are Set alarm, Reset alarm,
Remove alarm, Settings, Help, and Exit.
Select Menu > Clock.
To set a new alarm, select Options > Set alarm. Enter the
alarm time, and select OK. When the alarm is active, is
shown in the standby mode.
To turn off the alarm, select Stop. When the alarm tone
sounds, select Snooze to stop the alarm for five minutes,
after which it will resume. You can do this a maximum of
five times.
If the alarm time is reached while the device is switched
off, the device switches itself on and starts sounding the
alarm tone. If you select Stop, the device asks whether you
want to activate the device for calls. Select No to switch
off the device or Yes to make and receive calls. Do not
select Yes when wireless phone use may cause
interference or danger.
To cancel an alarm, select Clock > Options >
Remove alarm.