Filter
Top Products
Copyright © 2007 Nokia. All rights reserved.
Settings
101
To change the settings for a TV-Out connection, select TV-
Out and from the following:
Default profile — Set the profile that you want activated
each time you connect a Nokia Video Connectivity Cable to
your device.
TV screen size — Select the aspect ratio of the TV: Normal
or Widescreen for widescreen TVs.
Tv system — Select the analog video signal system that is
compatible with your TV.
Flicker filter — To improve image quality on the screen of
your TV, select On. The flicker filter may not diminish
image flicker on all TV screens.
Security
To edit settings related to the security, press , and
select Tools > Settings > General > Security > Phone
and SIM card, Certificate management, or Security
module.
Phone and SIM card
PIN code request — When active, the code is requested
each time the device is switched on. Deactivating the
personal identification number (PIN) code request may not
be allowed by some SIM cards.
PIN code, PIN2 code, and Lock code — You can change
the lock code, PIN code, and PIN2 code. These codes can
only include the numbers from 0 to 9. If you forget any of
these codes, contact your service provider. See "Glossary of
PIN and lock codes", on page 102.
Avoid using access codes similar to the emergency
numbers to prevent accidental dialling of the emergency
number.
Keypad autolock period — Select whether the keypad is
locked when your device has been idle for a certain period
of time.
Phone autolock period — To avoid unauthorised use, you
can set a time-out after which the device automatically
locks. A locked device cannot be used until the correct lock
code is entered. To turn off the autolock period, select
None.
See "Glossary of PIN and lock codes", on page 102.
When the device is locked, calls may be possible to the
official emergency number programmed into your device.
Tip! To lock the device manually, press . A list of
commands opens. Select Lock phone.
Lock keys if slide closed — Select whether the keypad is
locked when you close the 2-way slide.
Tip! To lock or unlock the keypad manually, press
, then .