Filter
Top Products
Copyright © 2007 Nokia. All rights reserved.
Make calls
78
Make calls
Voice calls
1 In the standby mode, enter the phone number,
including the area code. To remove a number, press .
For international calls, press twice for the +
character (replaces the international access code), and
enter the country code, area code (omit the leading
zero if necessary), and phone number.
2 Press to call the number.
3 Press to end the call (or to cancel the call attempt).
Pressing always ends a call, even if another
application is active. Closing the slide does not end an
active voice call.
To adjust the volume during a call, use the volume key on
the side of your device. You can also use the scroll key. If
you have set the volume to Mute, select Unmute first.
To make a call from Contacts, press , and select
Contacts. Scroll to the desired name, or enter the first
letters of the name to the search field. Matching contacts
are listed. To call, press .
You must copy the contacts from your SIM card to
Contacts before you can make a call this way. See "Copy
contacts", on page 88.
To call a recently dialled number in the standby mode,
press . Scroll to the number, and press .
To send an image or a video clip in a multimedia message
to the other participant of the call, select Options > Send
MMS (in UMTS networks only). You can edit the message
and change the recipient before sending. Press to send
the file to a compatible device (network service).
To put an active voice call on hold while answering another
incoming call, select Options > Hold. To switch between
the active and the held call, select Options > Swap. To
connect the active and held calls and drop yourself from
the line, select Options > Transfer.
To send DTMF tone strings (for example, a password),
select Options > Send DTMF. Enter the DTMF string or
search for it in Contacts. To enter a wait character (w) or
a pause character (p), press repeatedly. Select OK to
send the tone. You can add DTMF tones to the Phone
number or DTMF fields in a contact card.
Tip! When you have only one active voice call, to put
the call on hold, press . To activate the call, press
again.
During an active call, to route the sound from the handset
to the loudspeaker, select Options > Activate