Filter
Top Products
Copyright © 2007 Nokia. All rights reserved.
Settings
109
• Authentication type — Select Open or Shared for the
authentication type between your device and the
wireless LAN access point device.
• WEP key settings — Enter WEP encryption (length of
the key), WEP key format (ASCII or Hexadecimal), and
WEP key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2:
• WPA/WPA2 — Select the means of authentication:
EAP to use an extensible authentication protocol (EAP)
plug-in, or Pre-shared key to use a password.
Complete the appropriate settings:
• EAP plug-in settings (only for EAP) — Enter the
settings as your service provider instructs.
• Pre-shared key (only for Pre-shared key) — Enter a
password. The same password must be entered on the
wireless LAN access point device.
• WPA2 only mode (only for WPA/WPA2) — Select
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage — Define a home page.
Select Options > Advanced settings and from the
following:
IPv4 settings: Phone IP address (the IP address of your
device), Subnet mask (the subnet IP address), Default
gateway (the gateway), and DNS address. Enter the IP
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address — Select Automatic, Well-
known, or User defined.
Ad-hoc channel (only for Ad-hoc) — To enter a channel
number (1-11) manually, select User defined.
Proxy server address — Enter the address for the proxy
server.
Proxy port number — Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data connection — If you select When available
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to establish a packet
data connection. If you select When needed, the device
uses a packet data connection only if you start an
application or action that needs it.
Access point — The access point name is needed to use
your device as a packet data modem to your computer.
High speed packet access — Enable or disable the use of
HSDPA (network service) in UMTS networks. For more
information on HSDPA, see "Fast downloading", on page 4.