Filter
Top Products
Data and fax software setup
[ 33 ]
11
Select the correct modem
Each fax application typically has a setup menu that can be used to alter
the settings for your modem, as well as define how and when calls are to
be received (for example, immediately, on the third ring, etc.). This menu
may also provide you with a list of available modems that you can use when
sending and receiving fax calls.
Use your fax program settings menu to select your phone as the active fax
modem.
Confirm hardware settings
Use the modem properties dialog box of your fax software to confirm the
following settings:
• Communications port: COMnn (where nn the virtual COM port number
assigned to the DKU-5 data cable)
• Initialization: 19200 bps
• Modem type: Class 2.0
• Flow control: Hardware
Note: You may need to add the following initialization string to your fax software, even though the program provides a
drop-down list or checkbox for setting the fax mode/class: AT+FCLASS=2.0
• LEARN ABOUT MANUAL SELECTION OF INCOMING CALLS
You can receive digital data or fax calls with your PC using your Nokia phone the same way that you would using your existing
modem.
Certain service providers require that you preset your phone to receive incoming data or fax calls, rather than having the phone
automatically detect the type of incoming call.
Note: Your service provider may have special requirements for inbound data and fax calls. Check with your service provider
to see if prearrangement of incoming data or fax calls is necessary.
Prearrange data and fax call settings in your data/fax software
Before you can successfully receive a digital data call or fax transmission in this situation, your phone must receive a special
command from your data or fax software. This command tells your phone that the next call it receives is a data call or fax
transmission.
Your data or fax programs should allow you to send additional commands to the modem when the program is launched or when the
fax software instructs the modem to receive a call. Use the modem configuration menu in your fax software to send the following
special initialization string to the modem:
To preset your phone to receive a data call, use the following AT command: AT+CSP=1
To preset your phone to receive a fax call, use the following AT command: AT+CSP=2
The following is an illustration of one fax program modem settings dialog box, and is provided as an example of how to configure
your software: