Filter
Top Products
Copyright © 2007 Nokia. All rights reserved.
Tools
107
Select Options > Advanced settings to change the
following settings:
Network type — Select the internet protocol type to use:
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address (for IPv4 only) — Enter the IP address of
your device.
DNS address — In Primary DNS address, enter the IP
address of the primary DNS server. In Secondary DNS
addr., enter the IP address of the secondary DNS server.
Contact your internet service provider to obtain these
addresses.
Proxy serv. address — Define the address for the proxy
server.
Proxy port number — Enter the proxy port number.
Wireless LAN access points
Follow the instructions from your service provider.
WLAN netw. name — Select Enter manually or Search
for netw.. If you select an existing network, WLAN netw.
mode and WLAN security mode are determined by the
settings of its access point device.
WLAN netw. mode — Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode — Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the
network supports them.
WLAN security sett. — Enter the settings for the selected
security mode:
Security settings for WEP:
Wep key in use — Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
Authentication type — Select Open or Shared for the
authentication type between your device and the wireless
LAN access point device.
WEP key settings — Enter WEP encryption (length of the
key), WEP key format (ASCII or Hexadecimal), and WEP
key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2
:
WPA mode — Select the means of authentication: EAP to
use an extensible authentication protocol (EAP) plug-in,
or Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP) — Enter the settings
as your service provider instructs.