Filter
Top Products
Copyright © 2007 Nokia. All rights reserved.
Tools
108
Pre-shared key (only for Pre-shared key) — Enter a
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption — Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage — Define a home page.
Select Options > Advanced settings and from the
following:
IPv4 settings: Phone IP address (the IP address of your
device), Subnet mask (the subnet IP address), Default
gateway (the gateway), and DNS address — Enter the IP
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address — Select Automatic,
Well-known, or User defined.
Ad-hoc channel (only for Ad-hoc) — To enter a channel
number (1-11) manually, select User defined.
Proxy serv. address — Enter the address for the proxy
server.
Proxy port number — Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn. — If you select When available and you
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data
connection. If you select When needed, the device uses a
packet data connection only if you start an application or
action that needs it.
Access point — The access point name is needed to use
your device as a packet data modem to your computer.
SIP settings
SIP (Session Initiation Protocol) settings are needed for
certain network services using SIP. You may receive the
settings in a special text message from your service
provider. You can view, delete, or create these setting
profiles in SIP settings.
Data call
The data call settings affect all access points using a GSM
data call connection.
Online time — Set the data calls to disconnect
automatically after a time-out if there is no activity. To
enter a time-out, select User defined, and enter the time
in minutes. if you select Unlimited, data calls are not
disconnected automatically.