To switch between the two calls, select Swap. To
connect an incoming call or a call on hold with an
active call and to disconnect yourself from the calls,
select Options > Transfer. To end the active call,
press the end key. To end both calls, select
Options > End all calls.
Voice dialling
Your device supports enhanced voice commands.
Enhanced voice commands are not dependent on
the speaker’s voice, so the user does not record
voice tags in advance. Instead, the device creates a
voice tag for the entries in contacts, and compares
the spoken voice tag to it. The voice recognition in
the device adapts to the main user’s voice to
recognise the voice commands better.
The voice tag for a contact is the name or nickname
that is saved on the contact card. To listen to the
synthesised voice tag, open a contact card, and
select Options > Play voice tag.
Make a call with a voice tag
Note: Using voice tags may be difficult in a
noisy environment or during an emergency, so you
should not rely solely upon voice dialing in all
circumstances.
When you use voice dialling, the loudspeaker is in
use. Hold the device at a short distance away when
you say the voice tag.
1. To start voice dialling, in the standby mode,
press and hold the right selection key. If a
compatible headset with the headset key is
attached, press and hold the headset key to start
voice dialling.
2. A short tone is played, and Speak now is
displayed. Say clearly the name or nickname that
is saved on the contact card.
3. The device plays a synthesised voice tag for the
recognised contact in the selected device
language, and displays the name and number.
After a timeout of 2.5 seconds, the device dials
the number. If the recognised contact was not
correct, select Next to view a list of other
matches or Quit to cancel voice dialling.
If several numbers are saved under the name, the
device selects the default number if it has been set.
Otherwise the device selects the first available
number in a contact card.
122
Make calls
© 2008 Nokia. All rights reserved.