Filter
Top Products
Using the ONIS Vox 200 answerphone (remote use)
39
During remote accessing
The following table shows the functions available during remote access.
Press followed by the key which corresponds to the function you want.
Once played, messages are automatically stored and listed as read in the Log.
If left inactive for 40 seconds, the answerphone will automatically hang up.
Remote-activating the answerphone
Dial your telephone number.
After nine rings, the answerphone will pick up and emit a hold tone.
Press followed by your remote access code.
Press to activate your answerphone and hang up.
Enter the code to record a new outgoing message.
Record your new outgoing message.
To stop recording, press
.
3
2
1
4
3
2
1
The initial answerphone code is
“0000”.
Your answerphone will use the
last recorded outgoing message.
Keys Function
Play messages or stop playback
Record a new outgoing message
Activate or deactivate the answerphone
Delete the message being played
Play the previous message
Play the message again
Play the next message.
Remotely-changing the outgoing message
The ONIS Vox 200 enables you to change outgoing message remotely for the Ans+Rec or Ans mode).
You cannot change the pre-programmed message.
When remotely-accessing your answerphone:
Record begins after the tone.
Warning:the last outgoing
message will be deleted.
The message will be played for
you to check.
The answerphone will then revert
to standby mode.
utiliser le rep a distance 19/04/01 14:53 Page 39