Filter
Top Products
SpectraLink 8020/8030 Wireless Telephone Configuration
1725-36030-001_B.doc 31
Press LINE and then navigate to the desired domain. Press NavOK to set
the domain.
01 - North America
02 – Europe
03 – Japan
04 – Singapore
05 – Korea
06 – Taiwan
07 – Hong Kong
802.11 config
Once the regulatory domain is set, the 802.11 Config modes are
displayed. Only one may be chosen.
802.11(b & b/g mixed) is the
default. Press
NavOK to set the mode. If the mode has subbands, the
Subband list will open. If the mode does not have subbands, the
Transmit Power list will open.
Use g only if all of your infrastructure devices use only 802.11g. The
handsets will operate up to 54 mb/s in this mode.
Use b & b/g mixed if some of your infrastructure components only
understand 802.11b. The handsets will operate up to 11 mb/s.
Subbands have not been established for the b and b/g mixed or the
g only mode at this writing. Provision is made in the software to
accommodate these ranges once established. Newly added
subbands may not appear in the above table.
Subband
Once a mode is set the subband list will display, if applicable.
Only those ranges which are allowed in the set regulatory domain
and that pertain to the set mode are displayed. Note that for
802.11a the bands labeled
DFS will vary depending on the set
regulatory domain. Multiple subbands may be set. Navigate to the
desired subband and set with
NavOK. The Transmit Power menu
will open. Once the
Transmit Power setting is done, you will be
returned to the subband list.
To deselect a subband, navigate to it and press
NavOK.